ALPS Manufacturer of Electronic Components/Parts Catalog
close
> Switches/Encoders > Rotary Switches
> SRBM Series > SRBM121300
Related information
｜Dimensions ｜Mounting Hole Dimensions ｜Circuit Diagram and Dummy Terminals ｜Shaft Style ｜
｜Attached Parts ｜

6-positions Horizontal Type Rotary Switch SRBM Series

Detail

Model No. SRBM121300

Number of wafer 1
Poles 2
Positions 2
Changeover angle 30±3°
Changeover timing Non shorting
Rotational torque 40±20mN·m
Actuator configuration Flat
Actuator length L: 15mm
Minimum packing unit (pcs.) 100

Operating temperature range -40℃ to +85℃
Rating (max.)/(min.) (Resistive load) 0.1A 16V DC/50µA 3V DC
Electrical performance Contact resistance (Initial performance/After lifetime) 50mΩ max./150mΩ max.
Insulation resistance 100MΩ min. 100V DC
Voltage proof 100V AC for 1 minute
Mechanical performance Terminal strength 5N for 1 minute
Actuator strength Rotational direction 0.5N·m
Push direction 100N
Wobble of actuator (load at the tip of shaft: 5N) Measuring position from mounting surface 10mm
Shaft wobble (max. value) 0.17mm max.
Applicable mounting dimension 15mm
Vibration 10 to 55 to 10Hz/min., the amplitude is 1.5mm for all the frequencies, in the 3 direction of X, Y and Z for 2 hours respectively
Resistance to soldering heat Manual soldering 350±10℃, 3(+1, 0)s
Dip soldering 260±3℃, 5s max.
Durability Operating life without load 10,000 cycles 100mΩ max.
Operating life with load (Load: as ratings) 10,000 cycles 150mΩ max.
Environmental performance Cold -20±2℃ for 96h
Dry heat 85±2℃ for 96h
Damp heat 40±2℃, 90 to 95%RH for 96h

Dimensions

Rotary Switches

Mounting Hole Dimensions

Rotary Switches

 
Viewed from direction A in the dimensions.

Circuit Diagram and Dummy Terminals

Rotary Switches

 
1. Viewed from direction A.
2. For positions 2, 1 section consists of 2-poles.

Shaft Style

* Flat Shaft
  The shaft shows the position in which it is turned fully counterclockwise.

Attached Parts

Hexagonal nut (Unit: mm)
Flat washer (Unit: mm)
 
The following parts are included with the product.

Notes are common to this series/models.
  • All the axis are die casting shafts.
  • Place your purchase order in N minimum package units (N: integer).
  • Ask us for the export packaging unit.
  • Products other than those listed in the above chart are also available. Please contact us for details.
  • This products can be used in vehicles.
    Although these products are designed to perform over a wide operating temperature range, please ensure that you receive and read the formal delivery specifications before use.
Inquiries about Products
For more information please contact: Products Information Center.
1-7, Yukigaya-otsuka-machi, Ota-ku, Tokyo, 145-8501, Japan
Phone: +81 (3) 5499-8154
COPYRIGHT(C) 1995-2008 ALPS ELECTRIC CO.,LTD.