|
Operating temperature range
|
-40℃ to +85℃
|
|
Ratings (max.) (Resistive load)
|
1A 14.5V DC
|
|
Electrical performance
|
Contact resistance (Initial performance/After lifetime)
|
100mΩ max. (Initial performance)
|
|
Insulation resistance
|
3MΩ min. 100V DC
|
|
Voltage proof
|
100V AC for 1 minute
|
|
Mechanical performance
|
Actuator strength
|
Operating direction
|
90N
|
|
Pulling direction
|
30N
|
|
Vibration
|
10 to 55 to 10Hz/min., the amplitude is 1.5mm for all the frequencies, in the 3 direction of X, Y and Z for 2 hours respectively
|
|
Resistance to soldering heat
|
Manual soldering
|
350±5℃, 3s max.
|
|
Reflow soldering
|
Refer to soldering conditions
|
|
Durability
|
Operating life without load
|
30,000 cycles
100mΩ max.
|
|
Operating life with load (Load: as ratings)
|
30,000 cycles
100mΩ max.
|
|
Environmental performance
|
Cold
|
-40±2℃ for 96h
|
|
Dry heat
|
85±2℃ for 96h
|
|
Damp heat
|
40±2℃, 90 to 95%RH for 96h
|
|
|
|
Double heating method with infrared heater.
|
|
|
2. Temperature measurement
|
|
Thermocouple 0.1 to 0.2 Φ CA(K) or CC(T) at soldering portion(copper foil surface).A heat resisting tape should be used for fixed measurement.
|
|
|
|
|
(1) The condition mentioned above is the temperature on the mounting surface of a PC board. There are cases where PC board's temperature greatly differs from that of the switch, depending on the PC board's material, size, thickness, etc. The above-stated conditions shall also apply to switch surface temperatures
|
|
|
((2) Soldering conditions differ depending on reflow soldering machines. Prior verification of soldering condition is highly recommended.
|
|
|
|
|
|
|
1. Consult with us for TACT switchTM washing conditions.
|
|
|
2. Prevent flux penetration from the top side of the TACT switchTM.
|
|
|
3. Switch terminals and a PC board should not be coated with flux prior to soldering.
|
|
|
4. The second soldering should be done after the switch returns to normal temperature.
|
|
Related information
Detail
