ALPS Manufacturer of Electronic Components/Parts Catalog
close
> Switches/Encoders > Multi Control Devices
> RKJXS Series > RKJXS1004001
Related information
｜Dimensions ｜Soldering Condition ｜Taping Specifications ｜

8-directional Stick Switch (with Center-push Function) RKJXS Series

Detail

Model No. RKJXS1004001

Type Switch
Number of operating shafts Single-shaft
Shaft material Resin
Switch ON position 7° max.
Travel (Push operation) 0.3±0.2mm
Minimum packing unit (pcs.) 950

Operating temperature range -20℃ to +70℃
Ratings (max.) (Resistive load) 10mA 5V DC
Electrical performance Output voltage 1V max. at 1mA 5V DC (Resistive load)
Directional resolution 8-direction
Insulation resistance 50MΩ min. 50V DC
Voltage proof 50V AC for 1 minute
Mechanical performance Direction application force 0.8±0.5N
Push application force 2.5±1.5N
Robustness of actuator Pushing direction 30N
Operation direction 20N
Solder heat resistance Manual soldering 350±10℃, 3(+1, 0)s
Reflow soldering Refer to soldering conditions
Durability Vibration 8.3±1 to 200±4 to 8.3±1Hz, 4.4G fixed (for 15 minutes/1 cycle), 3 angles each 2 hours
Operating life Directions 500,000 cycles
Center push 500,000 cycles
Environmental performance Cold -40±2℃ for 500h
Dry heat 85±2℃ for 96h
Damp heat 60±2℃, 90 to 95%RH for 96h

Dimensions

Multi Control Devices


Soldering Condition

Example of Reflow Soldering Condition (Reference)
1. Heating method
Double heating method with infrared heater.
2. Temperature measurement
Thermocouple 0.1 to 0.2 Φ CA (K) or CC (T) at solder joints (copper foil surface). A heat resisting tape should be used to fix thermocouple.
3. Temperature profile
(1) The condition mentioned above is the temperature on the mounting surface of a PC board. There are cases where PC board's temperature greatly differs from that of the switch, depending on the PC board's material, size, thickness, etc. Care, should be taken to prevent the switch's surface temperature from exceeding 260°C.
(2) Soldering conditions differ depending on reflow soldering machines. Prior verification of soldering condition is highly recommended.

Taping Specifications

Taping Packaging
Reel Size
Number of Packages
1 reel 		950
Number of Packages
1 case (shipment within Japan) 		3,800
Number of Packages
1 case (shipment outside of Japan) 		3,800
Reel Width W (mm) W = 25.5
Tape width (mm) 24
 
Please place purchase orders for taping products per minmium package units (1 reel or a case).

Notes are common to this series/models.
  • Please place purchase orders for taping products per minimum package units （1 reel or a case）. Please see taping specifications.
  • Ask us for the export packaging unit.
Inquiries about Products
For more information please contact: Products Information Center.
1-7, Yukigaya-otsuka-machi, Ota-ku, Tokyo, 145-8501, Japan
Phone: +81 (3) 5499-8154
COPYRIGHT(C) 1995-2008 ALPS ELECTRIC CO.,LTD.