|
Operating temperature range
|
-40℃ to +85℃
|
|
Ratings (max.) (Resistive load)
|
25mA 24V DC (at opening and closing)
0.1A 50V DC (when energized)
|
|
Electrical performance
|
Contact resistance (Initial performance/After lifetime)
|
50mΩ max./100mΩ max.
|
|
Insulation resistance
|
100MΩ min. 500V DC
|
|
Voltage proof
|
500V AC for 1 minute
|
|
Mechanical performance
|
Terminal strength
|
5N for 1 minute
|
|
Actuator strength
|
Operating direction
|
10N
|
|
Pulling direction
|
10N
|
|
Vibration
|
10 to 55 to 10Hz/min., the amplitude is 1.5mm for all the frequencies, in the 3 direction of X. Y and Z for 2 hours respectively
|
|
Resistance to soldering heat
|
Manual soldering
|
350±5℃, 5s max.
|
|
Reflow soldering
|
Refer to soldering conditions
|
|
Durability
|
Operating life
|
Without load
|
3,000 cycles
|
|
With load
|
3,000 cycles (25mA 24V DC)
|
|
Environmental performance
|
Cold
|
-40±2℃ for 250h
|
|
Dry heat
|
85±2℃ for 250h
|
|
Damp heat
|
40±2℃, 90 to 95%RH for 250h
|
|
Example of Reflow Soldering Condition
|
|
|
Double heating method with infrared heater.
|
|
|
2. Temperature measurement
|
|
Thermocouple 0.1 to 0.2Φ CA (K) or CC (T) at soldering portion (copper foil surface). A heat resisting tape should be used for fixed measurement.
|
|
|
|
|
(1) The condition mentioned above is the temperature on the mounting surface of a PC board. There are cases where the PC board's temperature greatly differs from that of the switch, depending on the PC board's material, size, thickness, etc. The above-stated conditions shall also apply to switch surface temperatures.
|
|
|
(2) Soldering conditions differ depending on reflow soldering machines. Prior verification of soldering condition is highly recommended.
|
|
|
|
|
|
Related information
Detail
