|
Operating temperature range
|
-40℃ to +85℃
|
|
Electrical Performance
|
Total resistance tolerance
|
±20%
|
|
Rated power
|
0.05W
|
|
Maximum operating voltage
|
50V AC, 10V DC
|
|
Residual resistance
|
50Ω max.
|
|
Insulation resistance
|
100MΩ min. 250V DC
|
|
Voltage proof
|
300V AC for 1 minute
|
|
Mechanical Performance
|
Total rotational angle
|
300(+10, -5)°
|
|
Rotational torque
|
7.5±3.5mN·m
|
|
Stopper strength
|
0.5N·m
|
|
Push-pull strength
|
100N max.
|
|
Vibration
|
10 to 55 to 10Hz/min., the amplitude is 1.5mm for all the frequencies, in the 3 direction of X, Y and Z and for 2 hours respectively
|
|
Solder heat resistance
|
Manual soldering
|
350±10℃, 3(+1, 0)s
|
|
Reflow soldering
|
Refer to soldering conditions
|
|
Durability
|
Operating life
|
15,000 cycles
|
|
Environmental test
|
Cold
|
-40±2℃ for 240h
|
|
Dry heat
|
85±2℃ for 240h
|
|
Damp heat
|
60±2℃, 90 to 95%RH for 240h
|
|
Push-on switch specifications
|
Circuit / number of contact
|
Single pole and single throw (Push-on)
|
|
Travel
|
0.5±0.3mm
|
|
Operating force
|
5±2N
|
|
Ratings
|
0.1A 5V DC (1mA 5V DC min. ratings)
|
|
Contact resistance
|
100mΩ for initial period;
200mΩ after operating life
|
|
Operating life
|
100,000 times min.
|
|
Example of Reflow Soldering Condition
|
|
|
Double heating method with infrared heater.
|
|
|
2. Temperature measurement
|
|
Thermocouple 0.1 to 0.2 Φ CA (K) or CC (T) at soldering portion (copper foil surface). A heat resisting tape should be used for fixed measurement.
|
|
|
|
|
|
|
|
|
1. The condition mentioned above is the temperature on the mounting surface of a PC board. There are cases where the PC board's temperature greatly differs from that of the switch, depending on the PC board's material, size, thickness, etc. The above-stated conditions shall also apply to switch surface temperatures.
|
|
|
2. Soldering conditions differ depending on reflow soldering machines. Prior verification of soldering condition is highly recommended.
|
|
Related information
Detail
